Garden & OutdoorLast reviewed: November 2026

Gravel Driveway Calculator

A gravel driveway calculator works out the crushed-stone tonnage and truckloads for a new or resurfaced driveway. Enter length, width and depth, and it models the three-layer system — #3 ballast, crusher run and top dressing — with a 15% compaction allowance for heavy vehicle traffic.

Key facts:
  • A 60 by 12 ft driveway at 4 inches needs about 14.3 tons.
  • New driveways need 8 to 12 inches of stone in three layers.
  • Crown the centre 1/4 to 1/2 inch per foot of width.
  • Allow 15% extra for compaction under vehicles.

Loading calculator…

Share or Export Current Results

Share Gravel Driveway Calculator directly or copy link to clipboard

TwitterLinkedInFacebookWhatsApp

Calculation Formula & Mathematical Engine

Theoretical equation governing this computation.

Driveway_{tons} = \frac{Length_{ft} \times Width_{ft} \times (Depth_{in}/12)}{27} \times 1.40 \times 1.15

Variable Definitions

Driveway_{tons}Total gravel tonnage ordered
1.1515% compaction allowance under heavy vehicle roll-in
Depth_{in}Standard 4" resurfacing or 8-12" for new driveway excavation

Step-by-Step Calculation Example

60ft × 12ft Rural Driveway Resurfacing at 4" Depth

Scenario: Spreading a 4-inch layer of dense grade aggregate over an existing driveway.
Driveway Length60 ft
Driveway Width12 ft
Depth4 inches
Execution Steps
  1. 1Square footage: 60 × 12 = 720 sq ft
  2. 2Volume in cubic yards: 720 × (4/12) ÷ 27 × 1.15 = 10.2 cu yds
  3. 3Tonnage: 10.2 × 1.40 = 14.3 tons (approximately 1 full tri-axle dump truck)
Final Verified Output:14.3 Tons Crushed Stone (1 Tri-Axle Dump Truck Load)

Comprehensive Practical Guide

In-depth analysis, domain guidelines, standard practices, and common pitfalls.

The 3-Layer Driveway Construction System

Long-lasting gravel driveways feature three tiers: a 4-6" sub-base of heavy #3 crushed stone over geotextile fabric, a 4" middle layer of #57 stone, and a 2" top crown of crusher run with stone dust.

How Thick Should a New Gravel Driveway Be?

A new driveway needs 8 to 12 inches of stone in total: 4 to 6 inches of #3 ballast over geotextile fabric, 4 inches of #57 stone, and a 2-inch top layer of crusher run. A resurfacing job over a sound existing base needs only 4 inches of fresh top stone. Always crown the surface so water runs off to the sides instead of pooling in wheel ruts.

Frequently Asked Questions About Gravel Driveway Calculator

Direct, verified answers to common calculation and methodology questions.

Grade the center of the driveway 1/4 to 1/2 inch higher per foot of width than the edges so stormwater sheds into side ditches.
Authoritative Sources & Data References:
  • Federal Highway Administration (FHWA) Gravel Roads Maintenance Manual

Disclaimer: Crown slopes must be maintained to prevent vehicle rutting.